Archive for the ‘Solutions List’ Category

APFC PANEL (AUTOMATIC POWER FACTOR CORRECTION)

Posted on: October 31st, 2013 by admin No Comments
  • Used to improve and modify the efficiency of the power.
  • APFC Panel with Microprocessor based relay for controlling power factor within required values.
  • RTPFC Panels using Thyristor based capacitor switching.
  • Full ventilation type panel
  • Easy Maintenance and easily removable capacitor.
  • Use of capacitive duty contactors
  • Always maintain 0.99PF
  • High-speed power factor correction
  • Provision of detuned reactors for reliable operation in presence of harmonics.

MCC PANEL (MOTOR CONTROL CENTRE)

Posted on: October 31st, 2013 by admin No Comments
  • Used started control for all types of motors.
  • Duly wired with ACB/ MCCB/SFU/DOL/STAR- DELTA/ATS starters.
  • Various designs provided like single/double front, fixed type, with marshaling terminations.
  • Cubicle type extension on each side.

SYNCHRONIZING PANEL

Posted on: October 31st, 2013 by admin No Comments
  • Used to achieve the parallel operation between Gen sets.
  • Fully automatic synchronizing panels operated by microprocessor based relays.
  • Auto synchronizing, Manual synchronizing, Auto load sharing, Active & Reactive power management with protection such as U/ V, O/V, E/F, O/C IDMT, Reverse power, etc.
  • Load Balance metering such as Ammeter, Voltmeter, KW, PF, KWH, Double Frequency Meter & Synchroscope, etc.

ATS PANEL (AUTOMATIC TRANSFER SWITCH)

Posted on: October 31st, 2013 by admin No Comments
  • Used to switch an electric load back and forth between a primary source such as a generator utility and secondary source.
  • We provide many solutions for the interlock between the two sources which are used in the ATS incomer, such as:
    • Contactors
    • Motorized changeover switch
    • Motorized MCCB Fixed & products
    • Motorized ACB Fixed & Products

MDP PANEL (MAIN DISTRIBUTION PANEL)

Posted on: October 31st, 2013 by admin No Comments
  • Main Low voltage with totally type tested assembly comply with IEC 61439-182 up to 6300A.
  • Main Low voltage Panel, MDP With single, multiple incomers, bus couplers with proper interlocking.
  • Required protection, fault Indications, interlocking is provided.
  • Various design are offered in MDP like top, middle, bottom horizontal bus chamber panel with copper bus bars, Top/ bottom/ front/ rear cable termination, combinations of APFC Part with MDP.
  • Required facilities like, Cut-off of nonessential feeders at the event of failure of mains power.
  • Panel with provision to connect bus duct at main incomer side.